Power steering woes
 

Original slave cylinder type power steering. Steering spins wild when turning to left. Locks up to the right. With engine off wheels turn both ways no binding. Any help would would be great full

Re: Power steering woes
 

Moved to Wheels, Tires, Suspension and Brakes

Re: Power steering woes
 

Since it moves correctly with no load, but locks up or doesn't work with a load I would suspect the slave having issues. Like a blown seal between chambers.

Re: Power steering woes
 

wsignman. I am sending you the # of a shop that sorted my project out. I asked about your issue he said it is simple. Jack

Re: Power steering woes
 

Oldtrucksters I only got part of your message last word was (jack)
TKS Rich

Re: Power steering woes
 

I tried again.

Re: Power steering woes
 

Hi Rich. I am wrapping up at Johns shop and wont be at a computer until next Monday. I just talked to the vintage truck shop and he said you had not called. so I will pass what he said. You need to jack up the front wheels and start the truck. remove the dust cap at the end of the valve. turn the small nut. its a 7/16 th. this nut adjusts the relation of the initiation valve and the control spool. If its wild left you need to tighten the nut until the wheels go to center. then fine tune it to hold center. he said this assumes you put it together properly. Jack

Re: Power steering woes
 

He also added that bottom port on the valve goes to the bottom port of the cylinder. Jack.

Re: Power steering woes
 

Jack I will try the suggestions u sent me if those don't work I give the vintage shop a call TKS Rich PS what time zone is he in?

Re: Power steering woes
 

is it working?