Re: 1962 GMC 305V6 4WD Slow DD Build - Cecilia (Pic Heavy)
Before finding the wayward driveshaft I mentioned that I dropped the Rockwell T221. Here's how I did it.
First, I disconnected all of the drive shafts. There are two "U" bolts on every shaft with four nuts on the end of them. IIRC they're 1/2 inch bolts.
The rear shaft
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
The input shaft that goes to the transmission
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
And the front shaft
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Sorry for the pic quality. The camera got smudged and I didn't notice till I was copying the pics over.
The Ubolts probably won't just fall out once you get the nuts off. You can bang them with a hammer (put the nut back on a little so you don't buggar them up!) or use a big screwdriver to pry them off.
And you should tie or prop up the input shaft so it doesn't pull on the new gasket you put in and cause a leak later.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Take the cotter pin out of the shift linkage at the two points on the transfer case. Then pound the pin out with a hammer. I always put it back in afterwards (and the cotter pin) so it doesn't get lost.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Unscrew your speedometer cable
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
__________________
Step by steps:
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Some people are like slinkys. Not worth much but funny as heck when pushed down stairs.
__________________
If the women don't find you handsome, they should at least find you handy.
|