Re: Dana 44 carrier bearings, Detroit TrueTrac swap, axle shaft lengths, spline counts?
So my only real question now comes down to axle lengths...
Currie, Moser, and Dutchman Motorsports are the recommended places to go for off the shelf or custom axles. I have yet to check any of the reproduction parts catalogs LMC, Brothers, CPP, etc
And I'm wondering if any of the International half ton axles "61-74" will actually interchange? It saud those are a 5 on 5.5" pattern though? And I believe the Chevy truck 1/2 ton two-wheel drive pattern that I am after for a 75 or 76-91 Suburban for 75 or 76-87 pickup is a 5 on 5"? I'll have to go out and measure.
__________________
Chuck in Ohio
*'62 GMC 1000 Panel Truck - 305D/Saginaw 4sp soon: 351C V6 + AX15 5sp OD trans, & 73-87/91 disc brake front end, rear Cadillac calipers/ AWD Astro rotors, Dana 44 redrilled to 5 lug
*'88 Suzuki Samurai 4x4 project, VW 1.9L mTDI turbodiesel, Toyota V6 LandCruiser drivetrain, full floater axles, future LWB bed stretch
*'77-'79 Suzuki GS motorcycles, '76 Rickman CR900 roadracer.
*Dirtbikes: 2 Kawasaki KDX220R's, '77 Suzuki PE250, '83 PE175
|