[Hantke]

So I got the starter tested and it failed horribly, two different stores (gotta double check, right?) had it just make a loud thump then nothing. So I got a new starter thinking it was a good idea. The gear on the new starter is set so far back I don't even know how it could possibly connect if I wanted it to, and, the housing around the gear is actually between the gear mesh (go figure) so it will need to be trimmed. Is there a way adjust the positioning of the gear on the starter? The guys at the part store kept the booklet and the box to take my old core


Sent from my iPhone using Tapatalk