View Single Post
  #8  
Old December 1st, 2016, 04:46 PM
AZKen's Avatar
AZKen AZKen is offline
Senior Member
 
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,605
Rep Power: 513
AZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really nice
Default Re: Man Trans stuck in gear

This goes under the trans floor cover. It's been said that this is possibly "too short", that may mean too thin. You may need two or make one from proper foam. Buy two, they're cheap. Sits on top of trans and compressed by cover to seal. Boot adds more seal and trimmed look.
http://www.classicparts.com/1941-87-.../#.WEBThOnrs5s

Boot. Many types available. It's been said that no boot was used. I use boots and many Chevy and GMC guys do also. This one fits perfectly over the SM420 shifter boss and looks nice. The rubber is probably old Chinese shoe soles and does not last a long time.
http://www.classicparts.com/1941-66-.../#.WEBTy-nrs5s

I see you asked the same question another post RE: Boot and sponge. Now you have the Full Monty.

The above listed company has a good return policy, I.E. "for any reason". If it does not fit or perform properly you are protected.

Last edited by AZKen; December 1st, 2016 at 06:33 PM.
Reply With Quote