vrenlos
July 28th, 2015, 06:29 PM
Hello all,
I'm new to these parts and recently picked up a '62 fenderside. The previous owner disassembled a lot of the interior and I'm trying to piece it back together. While I had the seat out I cleaned the floor a bit and put a new sender gasket & filler neck on the gas tank. My question is this - there are a set of adjustable rails on the bottom of the seat, but it looks very low and as if the angle isn't quite right. Is there some sort of riser/bracket/feet to bolt the sliding rails to the floor? Or should I just fab something up right quick?
If I do wind up making something, what's the proper seat height/angle? Thanks a million!
I'm new to these parts and recently picked up a '62 fenderside. The previous owner disassembled a lot of the interior and I'm trying to piece it back together. While I had the seat out I cleaned the floor a bit and put a new sender gasket & filler neck on the gas tank. My question is this - there are a set of adjustable rails on the bottom of the seat, but it looks very low and as if the angle isn't quite right. Is there some sort of riser/bracket/feet to bolt the sliding rails to the floor? Or should I just fab something up right quick?
If I do wind up making something, what's the proper seat height/angle? Thanks a million!