Aotte
October 7th, 2019, 12:21 AM
Primed the 1966 V6 351E with the oil pump.
1). Removed the distributor and used 1/4 drive 5/16 6 point socket with 8” extension ( make sure extension fits socket tightly so you can remove it when done). Would only use 5/16 6 point socket as it fits exactly, where the distributor fit. It should be a 6 point socket to fit correctly. You can also remove the valve covers to see oil being pumped out push rods, to verify complete priming.
2). Attached a short 1/4” extension to 1/2” variable speed electric drill.
3). Placed the 5/16 socket with extension on the oil pump 5/16 shaft with 6 points, in the block. This is where the bottom of distributor connects to oil pump shaft.
4). Placed the drill with short extension into the extension/socket in distributor hole of block.
5). Slowly start turning the socket/extension with drill. Increase drill speed slowly to estimate engine idle.
6). Ran drill for 1 to 2 minutes to get complete circulation, in original engine with dried crude, not run for 3 to 5 years. Wanted a really good priming of bearings.
Hope this is helpful, comments welcome.
Will post photos soon.
Les
Sent from my iPad using Tapatalk
1). Removed the distributor and used 1/4 drive 5/16 6 point socket with 8” extension ( make sure extension fits socket tightly so you can remove it when done). Would only use 5/16 6 point socket as it fits exactly, where the distributor fit. It should be a 6 point socket to fit correctly. You can also remove the valve covers to see oil being pumped out push rods, to verify complete priming.
2). Attached a short 1/4” extension to 1/2” variable speed electric drill.
3). Placed the 5/16 socket with extension on the oil pump 5/16 shaft with 6 points, in the block. This is where the bottom of distributor connects to oil pump shaft.
4). Placed the drill with short extension into the extension/socket in distributor hole of block.
5). Slowly start turning the socket/extension with drill. Increase drill speed slowly to estimate engine idle.
6). Ran drill for 1 to 2 minutes to get complete circulation, in original engine with dried crude, not run for 3 to 5 years. Wanted a really good priming of bearings.
Hope this is helpful, comments welcome.
Will post photos soon.
Les
Sent from my iPad using Tapatalk