View Full Version : Carb Number deciphering
Funky61
December 15th, 2020, 09:27 PM
Happy Holidays to All and I hope you're all doing well!
I am asking if some one can read this carb number. It looks to be over stamped with the part number. This came off of a 1967 351E so its a Stromberg WWC.
It was free and I was going to rebuild it.
Let's see what you can see...and thanks for your input.
Henry
LEWISMATKIN
December 16th, 2020, 01:25 AM
Best guess 23-197a VERIFIED ON "THE CARBURETOR SHOP"'S WEBSITE.
Funky61
December 16th, 2020, 04:46 AM
Thanks Lewis!
I’ll look them up
AZKen
December 16th, 2020, 05:00 AM
What is the jagged blackout at the right side? If there is an "A" after the far right "7", they are the same number. Otherwise they are the same number and one has an "A" and the other does not. Carb Shop shows 1967 351 for 23-197. Do not see an "A". But there was an "A" revision carb.
Funky61
December 16th, 2020, 05:05 PM
Thank you AZKen, it was hard to read and again I though it was a GMC Part number.
Appreciate all the input and reference to the Carb Shop too.
BobBray
December 17th, 2020, 05:44 AM
23-197 is a Bendix-Stromberg number. The GM part number for that carburetor is 8867232, and it's WWC for a 351E without an AIR pump. When you rebuild it, pay particular attention to the air horn (top cover) and make sure that the bottom is perfectly flat. Common problem with the WWC was over-tightening the air cleaner wing nut would pull up and distort the air horn, and cause an internal vacuum leak. Other than that, the WWC was a good carburetor
FetchMeAPepsi
December 17th, 2020, 02:18 PM
23-197 is a Bendix-Stromberg number. The GM part number for that carburetor is 8867232, and it's WWC for a 351E without an AIR pump. When you rebuild it, pay particular attention to the air horn (top cover) and make sure that the bottom is perfectly flat. Common problem with the WWC was over-tightening the air cleaner wing nut would pull up and distort the air horn, and cause an internal vacuum leak. Other than that, the WWC was a good carburetor
Funky this topic is one of the reasons I love this place. Where else can you say "I found an old carb in an old wooden chest buried in an oil pit in the scrap yard that burned down in 1971. Here's a garbled number off the side. What can I do to rebuild it?".
Then get the part number, links to a rebuild kit, common problems to look for, the history of the carb, and it's parent's DNA sample mailed to the front door. Try doing that with most places and all you get is blank stares or some 15 year old kid telling you you're retarded for not buying some cheap chinese junk for 15.00 on bingbong.china.com
:thumbsup::thumbsup::thumbsup::thumbsup:
Funky61
December 17th, 2020, 04:09 PM
Thanks for the tip BobBray.
Fetch, your input and writing style are always enjoyable!
Thanks Guys!!
AZKen
December 17th, 2020, 07:01 PM
I have relatives in BingBong. I'm offended.
BobBray
December 19th, 2020, 06:20 AM
I used to be 15 years old!
lizziemeister'sV6
December 19th, 2020, 12:33 PM
I once believed that in the Great United States of America that an honest election could/would occur and that the Courts would uphold the Constitution which the Country was based on.
FetchMeAPepsi
December 19th, 2020, 02:57 PM
Well looks like I offended everyone, even Lizzie and I didn't even hack the election! :ahhhh:
If you're offended I'd like to send you a gift of apology. Send me your address and I'll send you a big crate of TWO, that's right, TWO residents of Bingbong china, that are obviously not spies interested in talking you into running for political office (obviously!). These two BingBongians will happily fulfill your every wish. Especially if your name is anything close to "Eric" or "Swalwell".
Just write your address on the back of any dirty $20 bill and send it to:
Fet Chmia Pep-Si
42 Ho Chi Min Trail
WalaWalaBingBong, Tai Chi, 66666
Free Country of North Vietnam
(Not affiliated with China, Inc or it's subsidiaries...No, really we promise!)
I eagerly await your response, honorable friends!
:deadhorse: <---- Join us for dinner!
snazzypig
December 19th, 2020, 06:35 PM
Dear Fet Chia Pet,
Way to go! I'm not offended, and do appreciate your generous offer!
LEWISMATKIN
December 19th, 2020, 10:44 PM
Good evening, folks!
just parusin' the previous feed, and noticed that ya'll had no mention of the hon. Gen. Robert E. Lee, or any of his Confederate counterparts. For shame, For shame on you all!!!!:ahhhh::happy::happy::happy::happy:
FetchMeAPepsi
December 20th, 2020, 04:59 AM
Good evening, folks!
just parusin' the previous feed, and noticed that ya'll had no mention of the hon. Gen. Robert E. Lee, or any of his Confederate counterparts. For shame, For shame on you all!!!!:ahhhh::happy::happy::happy::happy:
Robert E. Lee, as requested!
jmfurgason
December 21st, 2020, 07:09 PM
The USA did have a fair and honest election that the Supreme Court and the constitution has upheld and we are fortunate to escape the ruin of our democracy by a wanna be dictator. Merry Christmas
AZKen
December 21st, 2020, 08:18 PM
The USA did have a fair and honest election that the Supreme Court and the constitution has upheld and we are fortunate to escape the ruin of our democracy by a wanna be dictator. Merry Christmas
There are no facts in that statement. Just misinformation and lack of research. Not a good place to discuss that and then end it with Merry Christmas.
FetchMeAPepsi
December 22nd, 2020, 01:23 AM
The USA did have a fair and honest election that the Supreme Court and the constitution has upheld and we are fortunate to escape the ruin of our democracy by a wanna be dictator. Merry Christmas
Sorry brother, but Ken's right here. They didn't even look at the case or evidence, just like the other courts. They just said, "decline to hear". Search up the video of pulling suitcases of ballots out from under tables, how Biden won counties vs Hillary (hint, he did worse in all but the fishy counties in the fishy states...), and counting halted-monitors sent home-then counting resumed unmonitored.
I'm no die-hard Trump supporter, and I don't know that Trump won, but I know for a fact that things were not honest. Too much video to the contrary that everyone seems happy to ignore.
And on the Supreme court, the Texas suit was a dispute between the states, which is their main job. They HAVE to hear the case, even if they rule against it. The fact that they didn't is just astounding. What would they prefer, war between Texas and Pennsylvania? Without anyone to settle differences (as the constitution states) that's the only other option, fighting it out like schoolyard kids. I don't know what makes them think they can shirk responsibility like that.
Anyway, that's my 2 cents. Gotta pay attention to politicians. They like to chicken pluck you and train you to rely on them. Google Stalin Chicken pluck for a good time. :thumbsup:
vBulletin® v3.8.6, Copyright ©2000-2025, Jelsoft Enterprises Ltd.