Re: 305E torque specs crankcase Vent & timing question
Its in the shop manuals. And motors manuals. I don't have one here or I would post a pic.
|
Re: 305E torque specs crankcase Vent & timing question
Quote:
Mine has a twist on draft canister on each valve cover. At the time, I soaked them and cleaned them. As for the one in the block behind the driver side valve cover, I didn't do anyhting with it. It drips a little oil from the down tube each time after I drive it. I don't have any other leaks. Should I do something with the block canister with the down tube? Do I need to pull it off and flush it out? |
Re: 305E torque specs crankcase Vent & timing question
1 Attachment(s)
Quote:
Run engine until it reaches normal operating temperaure, tighten head bolts in proper sequence using 65-72 ft.lbs., and while the engine is still hot, adjust intake valve lash to 0.012" and exhaust valve lash to 0.018". Good luck. |
All times are GMT +1. The time now is 08:26 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.