Re: V6 Magnum Gaskets
I tried to make magnum exhaust gaskets out of a sheet of the same material as the regular exhaust gaskets. The scrapbook cutter I used didn't have enough pressure to cut the material. I wound up cutting them out manually. I was able to get set of magnum intakes from a board member.
|
Re: V6 Magnum Gaskets
Quote:
|
Re: V6 Magnum Gaskets
you must have a different 401M if the port size is the same as the 305, my 351E port size is alot bigger thus using a smaller 305 gaskets it hangs into the flow of the air/fuel mixture coming in, and or doesn't cover the complete gasketa surface area onto the outer edge ,sure it may seal up okay but may leak over time I just dont like the gasket haanging in the way from intake into cylinder head, did you see my pictures?
|
Re: V6 Magnum Gaskets
I'll post another picture tomorrow of the size difference of the ports 305 vs 351E, then may you can understand what I'm trying to accomplish, maybe I have a one of kind 351E with very large ports or the 401M were smaller then the 351E? I've only had 305s apart this is my first 351, you can clearly see the differences in size with naked eye, thanks
|
Re: V6 Magnum Gaskets
Quote:
|
Re: V6 Magnum Gaskets
Quote:
|
Re: V6 Magnum Gaskets
Quote:
|
Re: V6 Magnum Gaskets
well the gaskets are not even close to the same as such they will hang in the air fuel path causing performance problem so i will be copying my old gaskets and making my own, pictures to follow
|
Re: V6 Magnum Gaskets
2 Attachment(s)
well when you cant buy them make them!
|
All times are GMT +1. The time now is 01:47 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.