Re: 1962 GMC 305V6 4WD Slow DD Build - Cecilia (Pic Heavy)
After that just lift off "the bottom plate" and set it aside. This completes the disassembly portion of our show!
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
You can now start cleaning your parts! Grab a wipe-off towel and it better be a big one because you'll have almost a full towel of funk.
I took the air horn and dipped in the dip for 20 mins. The instructions say 15-30 mins. 20 mins seemed ok. Here's a before and after. I did have to dip the main body for two 30 min rounds though (not shown).
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Now it's safe to reattach the top back on the air horn. There is no replacement gasket in your bundle so treat it carefully.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Continue dipping parts, wiping them, and putting them back in their order. Set a timer so you get a reminder and keep parts moving through the dip. A simple egg timer that you steal from the kitchen is perfect. Buy her another one though because it's going to get nasty.
While that's happening we can open some plastic. Yummy fresh parts.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
This is part of what all you'll replace from the first package.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
You'll also replace these parts...
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
And here's the old ugly ones.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Next open up your new piston assembly. There's a bit of cardboard on the end of it - don't remove that until we're ready to put it back inside the carb.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
The old parts...
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Reassembly will commence tomorrow after the JB Weld dries
|