Re: My woodsplitter project
Hello Pepsi,
I follow your threads and really like how none of this stuff intimidates you. You jump right in there and get it done along with all of your dedicated helpers! About the only suggestion I have is when welding on a painted surface grinding all the paint off where you want to weld can improve the quality of the weld by not having to burn paint and then impurities from the burnt paint can lodge in the weld too.
The problem of the sun reflecting on the inside of the helmet and lense also happens indoors with shop lighting. I took an old hard hat liner and attached it to my helmet and it makes a huge difference in visibility. I just used double sided foam tape on the top and I had a couple of brass banner grommets I installed where the adjusting knobs are but just holes punched would be fine. This helmet is a "Cummings tools" auto darkening that cost $39.95 7 or 8 years ago.
It's was last spring I filled my torch bottles that I think are the same size as yours. Both bottles cost less than 30 bucks to fill. I bought my bottles from the welding supply shop that fills them. They just exchange instead of making the customer wait to fill the ones they brought in.
Keep it coming---DAC
__________________
Doug Crawford
Rapid City, SD
1970 GMC K5 Jimmy Mom drove 30 years
1972 GMC C2500 owned since 1979
1955 GMC 100 driver-project
2006 GMC Yukon Denali---wife's truck
Hope to have a '60 GMC Suburban again someday
|