Quote:
Glad you got the fitting situation sorted out. Is that a rebuildable cylinder? maybe it could be taken apart and freed up?
DAC
|
I don't know. I don't see any screws or anything on it to take it apart. Have you done one before?
I ran down to Tractor supply today and picked up another cylinder to see if that was the problem.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
It was. The new cylinder is 36" stroke (that means it can push out 36") and it's 2" around on the pusher part. The brand is Grizzly. It seems perfect for my splitter. I also found out that I wasn't mashing the switch far enough in either direction. My logic said that if you want the plunger to move slowly then mash the switch slowly. I didn't want it to slam out of there and break something (like me!) so I mashed on it slowly. That's not how hydraulics work apparently. You have to slam them all the way on or off. Not in between. I didn't know that.
At this point I was pretty excited. I ran over and grabbed a log, put it on the splitter, and mashed it to ON. It expanded perfectly until it hit the log against the blade, then it blew upwards and off to the side like a dog stretching. The pusher needs wings tying it to the beam. Oops.
I took a soapstone and marked the bottom of the pusher where the beam runs under it.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
I only have a few scraps of plate left to use for anything, but it should be enough. I plan to use one piece as a spacer and one piece as a "grabber" to grab on to the beam and guide the pusher down to the blade.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
I thought about welding them but then I'd never get them off
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
so i drilled three holes on each side and I'll run bolts through them.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?