[BarryGMC]

OK . The pic I described in my last post. thats the part that comes out. That outet groove Is where the screws on the big knob ride in. Put a 2.5 inch clamp in that groove and tighten it up then pry between the clamp and the hub just outside of where the large snap ring was. If you get it a little tap it in. Once you do thst a few it should just slide out. Disregard the flange in the pic this hub bolts on yours is splined. I am only using thsr hub because its a selectro ant the part protruding from your wheel hub is the same.