[FetchMeAPepsi]

This freed up the elephant trunk entirely so I pulled it out. It kept going, and going...



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?








And going! This thing must have been hooked up to Arkansas somewhere!



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?







It didn't seem to have any abrasions or anything weird with it either, besides a boatload of grease! I put it in my inherited purple wash bucket. It just barely fit. I'll get a better look at it after I clean all the grease off.

That left me with this paper gasket and a couple of metal brackets on the back of the knuckle.



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?







The back of the paper gasket had the other half of that metal bracket on it, but stuck to it real good. The one that fell must have been knocked loose by the impact wrench.



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?







Then I carefully worked the paper gasket off the knuckle. It didn't want to fit without tearing. I'll have to be careful with the replacement. It's a tight fit.



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?







Then I spotted this little cup bearing in the top hole (right under where it's shown in the pic). It goes under the "purposeless thing".



To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?