Quote:
|
BDI bearing is where I find most of my bearings and seals. Same with o rings. However I get the better viton o rings at a hydraulic supply and rebuilder shop. Here it is american hydraulic and chrome. The auto supply shops are more expensive and often staffed by dingbats. Also check the corn binder site for the bushing part # and knuckle bearing part #. They use the same dana front end except for wheel bolt pattern . I guess I am spoiled. I. Have 3 bearing supply shops within a half mile of each other. Two are on the same block. And one guy has most of the dana 4x4 stuff put to memory.
|
You are lucky! I'll try a few more places online so I can point to it and say "here is the part" for others, but if nothing pans out I'll get to schmoozing my local bearings stores. I would never have thought such a place existed. Who woulda thunk there was such a need for bearings that they make whole places dedicated to it?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Quote:
|
What O-rings are you looking for specifically?
Jonathon
|
I attached a pic of the O rings..well, where they go. They're two very tiny o-rings on the outside of the hub where the handle screws back on. I've got two rings on order from a place right now but they might be too thick. If you have a source or part number for them that'd be great!
Thanks for the other P/Ns too!
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Quote:
|
Fetch, this has been a joy to read! Keep up the awesome work! Kudos to barry and the others here with the support! Best of luck on Cecilia!
Cos
|
Thanks Cos! Welcome to the board! (saw it was your first post)
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?