Re: 1960 k1001
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Phase one complete, Motor Start. Seems to run good but Two of the **** new freeze plugs I put in leaked without pressure! I did not put any goop on them. Should have. I figured it was a waste of time, a press fit is a press fit. But castings are castings. Always did it before. Bottom long bolt on filter leaks a little. Nothing else so far. Temporary Valve covers while I "restore" the plaids. Oil pressure about 50.
Last edited by AZKen; October 25th, 2014 at 12:08 AM.
|