Re: Ok, were getting close to pulling the trans
Thanks AZKen. We'll have to block it up. I was able to press out the U-joint for the yoke on the driveshaft ( friend has a press) I went to a website called Driveshaft Specialist and they have the correct yoke I need to use with the rear of the 700R4 27 spline shaft. The Hydramatic used a 16 spline. I'll order the new spline and joint Friday.
Their website has a sweet measuring scale you can print out and use to select your U-Joint. I most probably need. 1310 joont. I'll post the measuring link tomorrow
|