I'm finishing up rebuilding a 64 305E. I have this clutch installed:
https://www.rockauto.com/en/moreinfo...&pt=1993&jsn=9
It's a 3-on-the-tree and I don't think the clutch is fully engaging. The clutch linkages all adjusted as far as they go. Also have a new clutch fork. When I have it in gear and hold the clutch and engage the brake, the engine dies. (It's on jack stands right now.)
Any recommendations? I'm not sure how to proceed from here. This is the last thing before getting the truck back on the road (first time since 2000).