Quote:
Originally Posted by krazzz
I am looking at installing a set of "triple gauges" for my '64 305E. I would like to keep the factory gauges/idiot lights in place. Is there a way to run both? I can only find one spot for a coolant temp sensor, does anyone know of an alternate location? I don't suppose it's possible to run two gauges off of one sending unit. For the oil pressure, I am guessing it is underneath by the oil filter but I have not found it yet. Need to get it up on a lift. Is there a second port somewhere that I could tap into?
|
I believe I did a write up on here somewhere when I did mine years ago, but for now I took a few photos this morning to share.
I built the triple gauge bracket using 16 ga sheet metal and used the same hole spacing as the above dash knobs. Bought the three gauges (coolant/vacuum/oil pressure) off eBay and I found a couple of period correct gauges (batt & tach) at a swap meet for the original dash cluster. For the batt and tach gauges I had to cut the plastic blanks out of the dash insert using a hole saw.
(Not sure why my two interior photos uploaded upside down?)