Re: '62 Rear Bearings & Seals
The splined axle shaft is 1.5 OD. The outer seal diameter and the bearing diameter are larger out at the hub end.
Sure seems like if the number you gave comes back as 38128 seal, that would be it.
The outer is bigger. Measure the seal you need for ID and OD and width and let us know. I hope you are measuring the seal and not the shaft at the wrong place
Anyway here is a possibility.
SKF 13165
My 1960 K1001 had an original dana 44.
I guess you could have a Eaton HO. Doubt it unless someone swapped.
Last edited by AZKen; July 30th, 2023 at 12:22 AM.
|