Re: Locking Tabs 4 Flywheel?
I have measured the degrees on an indexing head used in a machine shop, and this is what I have thus far:
The 379, 401, 432, & 478 flywheels have eight holes on a four-inch circle. The bolt holes are spaced out at 45 degrees except for one that is only 2 degrees offset.
The 351 flywheel has six holes on a four-inch circle. The bolts are spaced out at 60 degrees except for one that is offset by only 2 degrees.
My last task is to find a 305 crank/flywheel to measure. If anyone knows if the 305 and 351 flywheels are interchangeable, that will save me some time.
Off and running, Jim Mx.
|