[millspec]

Thank you. I suppose the actual first step is to get the drums measured to see if they are currently within spec and have enough material to be turned. I have to get a service manual to look the spec up as there’s no writing on the drums that I can find.
Would anyone happen to know what it would be? I’ll look it up when I get a manual, but would appreciate a cross check.
I admit I’m a bit nervous about having them turned. I messed up more than one drum when I worked at a parts store and (so far) I haven’t had any luck finding replacements.
The brakes didn’t pulsate when I took them apart, so they should be fairly round.
Thanks again for the help.


Sent from my iPhone using Tapatalk