Thread: Starting problems / ignition / distributor
View Single Post
  #4  
Old Yesterday, 08:34 PM
AZKen's Avatar
AZKen AZKen is offline
Senior Member
  
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,688
Thanks: 3
Thanked 8 Times in 8 Posts
Rep Power: 546
AZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really nice
Default Re: Starting problems / ignition / distributor
Do not remove distributor.

Cap off, all plugs out. Thumb over cylinder 1 hole. Turn motor with starter. Watch rotor. See where rotor is when pressure hits thumb. Watch several rotations to see if rotor repeats. report.

Also, where is harmonic balancer mark when rotor is in position shown in your photo?
Reply With Quote