[flyingA66]

Joe, I built a gauge panel because the old one was wasted so I prewired all the gauges, bright and turn signal leds and gauge lights. Got to get out the old test light and figure out the circuits and hook it up, in fact that is todays project. I like to solder and shrink wrap all the connections so it is a bit more time consuming than just crimping the connections. The heater loom is hanging and needs to be hooked up but I can't figure out the routing of the 4 heater cables, I hooked them up and they bind. I suspect the problem is because they are the length made for a C10 which has the heater controls on the other side of the dash next to the instrument cluster. If anybody could give me a clue as to the proper length and position of the cables I would much abliged. Then I could hook the heater up and install the glove box etc. Going to the Portland Swap Meet tomorrow, don't have any money to spend but I can drool, haha!