View Single Post
  #2  
Old July 31st, 2018, 07:32 AM
AZKen's Avatar
AZKen AZKen is offline
Senior Member
 
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,605
Rep Power: 513
AZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really nice
Default Re: Rust repair, where to start

I need to mention that sometimes a cab is actually too far gone. You could spend way more money than buying a GMC or Chevy donor. Keep that in mind.
Not being able to access your rust, there is some engineering to think about. Figure out which repairs will cause the cab to loose symmetry. To rack, to sag, to twist due to removing structural integrity. The floors control a lot of that. The door openings MUST be kept from moving with welded or bolted struts. Google this. Get pics of what others do on all era's of vehicles. Take dozens of measurements before starting. Measurements of things you don't even think you will need. I drill small holes in door and hood hinges, like 1/8 all the way thru hinges and cab. Then when reassembling, use the drill bit as a "pin" to align while tightening the bolts. You can make Datums also. Holes, punch marks etc, to maintain a measuring point that will not be cut away.

You are entering a difficult area regarding floors AND supports AND mounts. Careful thought is necessary, including my first comment. It's pretty good practice to just tack weld and make sure associated parts will fit before final weld.

The negative of a donor cab is the VIN/Title situation.
The guy has a ton of videos on 60-66 repairs. You have to dig thru his site and follow the sequence to get to a part you are doing.
https://www.youtube.com/watch?v=oydlEWgNths

Last edited by AZKen; July 31st, 2018 at 07:54 AM.
Reply With Quote