Quote:
Originally Posted by TRybas
Could someone please confirm these are the correct hinges for a 1960. Nothing appears to be bent but they are binding to the point where I can not close the hood. They move freely when the hood is not attached. Something is twisting when the hood is bolted on. I’ve tried everything. I believe they are original but maybe a previous own was in there before me.
|
I assume you've oiled all the pivot points. I have a similar problem with my '65 Suburban that may have nothing to do with your problem. If I open my hood too far, the linkage actually goes "over center". The only way to close it then is to pull that particular pivot point forward by hand to get it to close again. So I always stop just short of fully open when I lift the hood.