Re: inline six woes
Yes Doug. I have the carb on the right. The fuel inlet is positioned high ;same side as mixture screw. I did remove the upper part of the carb to look at float. I removed float to check drop. Ok on that. I looked closely at float fit ; ok on that too. I did not go deeper into carb for I didnt have any backup parts or gaskets.
the carb looks newly rebuilt. (remanufactured). Wonder if I run cleaner through tank if that would help. I like techron but I see that other use seafoam. Also heard about drying additive to remove moisture. Any suggestions.I have long thought i have excess fuel prob.
Am I going to loose my drive shaft? Other than vibration and occasional 1st gear clunk, not hearing any red flags or urgent fix.
THANKS again Doug
Oh yea, I do have standard mechanical fuel pump.
|