Re: Not getting power to coil
Electrical is not my thing so just a thought.
The resistance wire starts at the plug in the engine compartment. Disconnect it, turn the ignition switch to the run position. And check voltage at 18-p-3 on the R.H dash bulkhead connection in the wiring diagram. It should be 12v. If so pull the resistance wire and pin out of the plug and replace it with a new 18g wire and pin (not a resistance wire) and connect it to the coil. Then connect the Pertronix to the coil. No more resistance wire and 12v at the coil.
64 wiring diagram
Last edited by gmcjuniorvan; March 11th, 2022 at 05:09 AM.
|