[TRybas]

My baby took her first breaths yesterday. Didn’t get a good video. I’ll try to fire her up again today and post the vid. In the meantime been loose fitting the dash and electrical (American auto wire kit).

Gauge cluster needed a few repairs. Some of the copper on the board cracked and was being jumped by wire from a previous owner. Did a continuity testing around the whole board. Both brakes were at the fuel gauge. Cleaned it up with a wire wheel on the dermal and threw a little solder over it. Everything seems to be working for now.

Was also missing one of the ground wires. Couldn’t easily find the type female pin connectors so I used a standard barrel connector. Very close fit but a little loose; lightly crimped it to make good contact but still be able to slide on and off. Only had insulated ones on hand. Was easy enough to strip out. Soldered the wire into the barrel connector instead of crimping so it could be slid into the original round cluster.