Thread: Not getting power to coil
View Single Post
  #64  
Old March 11th, 2022, 12:02 AM
AZKen's Avatar
AZKen AZKen is offline
Senior Member
  
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,605
Rep Power: 514
AZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really nice
Default Re: Not getting power to coil
Good deal. I would suggest doing what the instructions recommend. No ballast, no resistance wire. Notice that 12V goes directly to the module no matter if resistance wire is used or not. This is the BIG MISTAKE folks make about using resistance with Pertronix. They wire it up like the points were wired. I fear that is what the other guy did.
Best to eliminate resistance altogether before you slow fry the Pertronix.
Last edited by AZKen; March 11th, 2022 at 12:07 AM.
Reply With Quote