Quote:
Originally Posted by bobdylan
Looking for proven techniques for removing pistons, one thing taht sounds good is, after soaking with? pack cylinder with grease, put a head that valves seal tight. modify spark plug and instal grease zerk, use pressure from grease gun to shve piston out. Has anyone tried this? Bob
|
The grease method sounds like a pretty good idea, it sure works slick for pressed in pilot bearings. The first pic below is a couple different rust breaker sprays I've had good luck with before. I've heard kerosene and ATF mix works well but never tried it.
Quote:
Originally Posted by ilvracn
Haven't tried it on pistons. I have a pistol that my uncle found when plowing about 50 years ago. I think it dates back to the late 1800 era. Tried soaking it in diesel fuel for 2 years, did no good. I put the pistol in a bucket of evaporust and soaked it for a couple months. I was then able to rock the cylinder a little bit. I was pretty excited about that. So put it back in bucket, but did not get back to it for a couple months. Wheni pulled it out another chemical reaction occured, and a white powder had formed on it. Pistol stuck again. What a bummer. So dont leave evaporust in too long.
|
Cool find! I wish I could remember how Mom de-rusted this pistol about 45 years ago but it came out well. I remember she soaked it in something for quite a while in our utility room and I don't remember it having a bad smell or anything. She found it while digging for old bottles at a long-gone railroad station, and it is also from around the same era.
Sorry about the brief hi-jack!
DAC