View Single Post
  #12  
Old September 9th, 2021, 08:57 PM
Jethro Jethro is offline
Member
 
Join Date: Jul 2021
Location: Pekin, IL
Truck: 1964 I1000
Age: 55
Posts: 45
Rep Power: 16
Jethro is on a distinguished road
Default Re: Ignition switch wiring help

You guys are great! I have the answers now to just exactly what I need to know. Thanks!

My truck does have the light green wire to the 4-pin panel connector but it ends right there. No wire in the cluster harness and an empty L pin.
Earlier in my adventures I found the temp sensor wire connected to the coil +. Maybe what fried the printed circuit? Pretty sure everything under the hood is right now. Went thru the park/turn lights too.
I just fixed the panel and don't want to fry this one.
I think I'll try it first just to check the gage and then run it unhooked. It seems redundant.

I rewrapped some of my harness with the original. The rest I used the plastic loom stuff and just taped the ends and a couple other wraps just to keep it closed. The fuse block is really rough. I'm looking for some replacement terminals. Or a used block. Either that or I'll have to install a more modern chip fuse block.
Reply With Quote