View Single Post
  #14  
Old September 10th, 2021, 01:55 AM
AZKen's Avatar
AZKen AZKen is offline
-= Dues Paid =-
 
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,284
Rep Power: 398
AZKen is a jewel in the roughAZKen is a jewel in the roughAZKen is a jewel in the roughAZKen is a jewel in the rough
Default Re: Ignition switch wiring help

Yes, that 20 L.GR 36 is shown dead ended on both ends. Not used.

Your fuse panel terminals are pretty rusty. I have actually sand blasted those terminals carefully and with the appropriate pressure to not destroy other areas of it. It would have to be removed to do that. If you are going to remove it to replace it, try that first. There are possible chemical rust removers that may not attack the plastic during a soak.

This is a good idea that you may find a way to use. By Edd China. Starts at around 9:45 https://www.youtube.com/watch?v=LzxeK6yp4hQ

Last edited by AZKen; September 10th, 2021 at 02:03 AM.
Reply With Quote