Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| Transmissions and Rear Ends Three on the tree or four in the floor? Shift it all here. |
 |
|
|
Thread Tools |
|
#1
May 30th, 2014, 04:15 PM
|
|||
|
|||
Need some advice on Clutch Spring disassembly
Hi everyone,
I have a '63 Stepside that I'm disassembling. The goal is to clean the rust/dirt/etc, so safety upgrades like disk brakes and move the gas tank to under the frame, etc. So far, so good; I am almost ready to remove the cab. However, I'm stuck on getting the clutch spring off, the one that is attached to the pedal in the cab. I am unable to strong-arm it with pliers or anything else. I'm guessing there is either a trick that I don't know (quite likely) or a tool I need to use, or both. Can anyone give me a clue on how to get this spring off? Many thanks, John 
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch Return Spring | Archiver | Previous Forum Posts | 0 | July 18th, 2006 02:51 AM |
| Clutch return spring? | Archiver | Previous Forum Posts | 0 | July 1st, 2004 02:57 AM |
| Clutch Assembly Advice | Archiver | Previous Forum Posts | 0 | March 20th, 2004 01:55 AM |
| Re: [6066 GMC Truck] Clutch Assembly Advice | Archiver | Previous Forum Posts | 0 | March 20th, 2004 01:40 AM |
| clutch fork retaining spring | Archiver | Previous Forum Posts | 0 | December 16th, 2002 01:03 AM |
