Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#2
July 26th, 2015, 01:37 AM
|
|||
|
|||
Re: 351 Crank pulley question
hello - 305 and 351 engines doesn't have a balancer up front on the crankshaft - the bolt you see just screws in the crank end and holds the pulley hub on -just unbolt and the hub should pull right off - it's on a keyway
|
|
#3
July 26th, 2015, 02:26 AM
|
||||
|
||||
|
Re: 351 Crank pulley question
Agreed no balancer, just a hub I guess, But I have 6 bolts surrounding the big bolt. I have already taken off once but forget. Take off big bolt AND the 6 bolts? Does it matter if one groove or two groove pulley?
Last edited by AZKen; July 26th, 2015 at 02:39 AM.
|
|
#4
July 26th, 2015, 02:05 PM
|
|||
|
|||
|
Re: 351 Crank pulley question
Morning - doesn't matter how many groove pulley it is - the 6 bolts are unevenly spaced so the pulley only fits the hub one way - I found it easier to remove the pulley or pulleys and then loosen/remove the big bolt that holds the hub on - should pull off easy.
|
|
#6
July 27th, 2015, 09:42 PM
|
|||
|
|||
|
Re: 351 Crank pulley question
AZ KEN I know this off topic but I just wanted to let you know I got the $10.00 dollars you sent back. Thanks. Ross.Hodges with '66 GMC with '12 flat bed.
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: [6066 GMC] Crank Pulley For A/C | Archiver | Previous Forum Posts | 0 | March 14th, 2006 04:56 AM |
| Crank Pulley For A/C | Archiver | Previous Forum Posts | 0 | March 14th, 2006 04:24 AM |
| Re: [6066 GMC Truck] Crank pulley seal Question | Archiver | Previous Forum Posts | 0 | July 8th, 2003 05:55 AM |
| Crank pulley seal Question | Archiver | Previous Forum Posts | 0 | July 8th, 2003 04:15 AM |
| RE: [6066 GMC Truck] Crank pulley seal Question | Archiver | Previous Forum Posts | 0 | July 8th, 2003 02:44 AM |
