Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#1
February 27th, 2021, 09:19 PM
|
||||
|
||||
305 Question about valves
Is a 305 an interference motor or not? In other words, if timing chain or gear breaks/stretches will valves hit piston or is there clearance? Some Chevy motors are interference motors and some are not. Don't know if GMC 305 V6 is or not? Thank you.
|
|
#2
February 28th, 2021, 11:40 AM
|
|||
|
|||
|
Re: 305 Question about valves
The 305 is a non-interference motor. I have measured the valve clearance on a stock 305 head and a magnum head. On the 305 with a valve lift of approximately .450" (valve wide open) lift it will still have a minimum of .150" clearance (piston at top dead center). On the magnum head with a valve lift of approximately .450" (valve wide open) lift it will still have a minimum of .120" clearance (piston at top dead center). Hope this help.
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| hyster 305 question | Archiver | Previous Forum Posts | 0 | March 4th, 2010 04:37 AM |
| Re: 351 heads/ 305 exhaust valves | Archiver | Previous Forum Posts | 0 | July 16th, 2009 01:21 AM |
| Re: [6066 GMC] 351 heads/ 305 exhaust valves | Archiver | Previous Forum Posts | 0 | July 15th, 2009 01:44 AM |
| 351 heads/ 305 exhaust valves | Archiver | Previous Forum Posts | 0 | July 15th, 2009 01:23 AM |
| Re: [6066 GMC] 351 heads/ 305 exhaust valves | Archiver | Previous Forum Posts | 0 | July 15th, 2009 01:00 AM |
