Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
 |
|
|
Thread Tools |
|
#1
September 6th, 2014, 10:42 PM
|
||||
|
||||
11" Clutch disc from Ebay
This appears to be correct for the V6; I say that only because it "looks" a lot like my spare and the cone is correct.. Perhaps someone else will verify the part number listed, as I've not run across it on Jolly's list.
http://www.ebay.com/itm/371081900177...%3AMEBIDX%3AIT Top two are from listing and the bottom; a Borg & Beck and a Hastings unit(s) I acquired as spares and post here for comparison.
__________________
1961 GMC Suburban 305A Overdrive 1962 GMC Utility 305D 
|
|
#3
September 7th, 2014, 03:53 PM
|
||||
|
||||
|
Re: 11" Clutch disc from Ebay
You can get them rebuilt for about that by taking your old one to a shop. I'd say somebody watch it and see if it goes down to about $50.00 shipped and then snag it.
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy.
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Long "School Bus" shifter | tatastruck | Transmissions and Rear Ends | 3 | January 23rd, 2013 06:08 AM |
| GMC 2 ton 6cyl "Toro-Flow" Diesel. No title. | Archiver | Previous Forum Posts | 4 | July 21st, 2011 04:03 AM |
| "E", "H", and "J" Cab models | Archiver | Previous Forum Posts | 2 | May 20th, 2011 09:04 AM |
| Clutch alignment tool or "pilot" shaft | Archiver | Previous Forum Posts | 4 | February 16th, 2011 02:07 PM |
| 11" clutch disc for 65' K1000 | Archiver | Previous Forum Posts | 0 | October 5th, 2004 02:34 AM |
