Pay Dues or become a Site Supporter |
|
GMC V6 and V12 Engines Engine repair and rebuilding |
|
Thread Tools |
#1
|
|||
|
|||
66 351E Rebuild Questions and Part needed
I pulled my stuck 351E. Honed the bores, looks good. New standard rings installed. Need a camshaft cover mine is rusted. I got gaskets from Olsons, the head gaskets are for a 401, they are 5 inches (piston size) my 351 is standard at 4 9/16. Will the gap cause an issue?
My truck is from Washington State, Auto, ps, pb, custom cab, with chrome grill and bumper. thanks guys. Chris |
#2
|
|||
|
|||
Re: 66 351E Rebuild Questions and Part needed
Gasket is fine. How much did Olsens charge? The cover should be easy enough, I have some, I am in kansas you might find one closer to home.
|
#3
|
|||
|
|||
Re: 66 351E Rebuild Questions and Part needed
Gasket is fine. How much did Olsens charge? The cover should be easy enough, I think they are the same as 305, could be wrong, hopefully someone will correct me. I have some, I am in kansas, you might find one closer to home.
|
#4
|
|||
|
|||
Re: 66 351E Rebuild Questions and Part needed
If I could get a cover that would be great. Send me a message on cost. Olson's charged $430 for a Head set.
|
#5
|
|||
|
|||
Re: 66 351E Rebuild Questions and Part needed
Sent PM
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
new to group/351E V6 rebuild | Samuel | GMC V6 and V12 Engines | 4 | March 9th, 2013 08:16 PM |
63-66 3/4T part needed | Archiver | Previous Forum Posts | 0 | November 18th, 2011 12:00 AM |
Clutch linkage questions - 66 GMC 351E | Archiver | Previous Forum Posts | 4 | March 31st, 2011 01:34 AM |
Cheapest place to buy a 351E rebuild kit? | Archiver | Previous Forum Posts | 0 | December 7th, 2009 05:17 AM |
Re: Cheapest place to buy a 351E rebuild kit? | Archiver | Previous Forum Posts | 0 | December 7th, 2009 12:27 AM |