Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#1
August 13th, 2019, 02:00 AM
|
||||
|
||||
Diameter of the 305 flywheel
Do any club members have the measurement of the 305 flywheel? If so can you post it. I need outside edge to outside edge.
Thanks Jake 
|
|
#2
August 13th, 2019, 03:20 AM
|
||||
|
||||
|
Re: Diameter of the 305 flywheel
JAKE, the o/d of the manual flywheel gear 2369440 (napa 6003026) is 16.00"/191t. I hope this helps.
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by LEWISMATKIN; August 13th, 2019 at 03:21 AM. Reason: added "gear"
|
|
#3
August 13th, 2019, 01:08 PM
|
||||
|
||||
|
Re: Diameter of the 305 flywheel
I was just checking to make sure because the flywheel for the new automatic trans. adaptor is 16" as well. I suspected as much because if not, the starter gear would not have made contact. Never hurts to check.
|
|
#4
August 14th, 2019, 03:19 AM
|
||||
|
||||
|
Re: Diameter of the 305 flywheel
Jake, I'd replace that starter ring gear while the parts are still uninstalled. Never hurts to put in a new wear part when the opportunity arises.
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
|
|
#5
August 14th, 2019, 04:05 AM
|
|||
|
|||
|
Re: Diameter of the 305 flywheel
Also he ring gear can be taken off and flopped over to the other side.
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: 305 flywheel | Archiver | Previous Forum Posts | 0 | August 19th, 2010 03:54 AM |
| Re: 305 flywheel | Archiver | Previous Forum Posts | 0 | August 18th, 2010 02:52 PM |
| Re: [6066 GMC] 305 flywheel | Archiver | Previous Forum Posts | 0 | August 18th, 2010 02:50 AM |
| Re: [6066 GMC] 305 flywheel | Archiver | Previous Forum Posts | 0 | August 18th, 2010 02:23 AM |
| 305 flywheel | Archiver | Previous Forum Posts | 0 | August 17th, 2010 01:08 AM |
