Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
#1
December 21st, 2019, 10:11 PM
|
|||
|
|||
Cab questions
I have a 63 cab and I have a question about the fresh air cab vents. I recently removed them to replace the gasket and repaint them upon removal I found the were being help in by double sided tape. My question is on the proper mounting is there a nut or clip for the back side
|
|
#3
December 23rd, 2019, 05:34 AM
|
||||
|
||||
|
Re: Cab questions
My cab is a 1966, but those vents were held in with sheet metal screws that went into that metal flange in the kick panel. Tape was likely a substitute for the gasket they used from the factory between vent and flange.
Hope that helps. Regards Steve New Orleans
|
|
#4
December 24th, 2019, 08:56 PM
|
||||
|
||||
|
Re: Cab questions
I assume "they" means the gaskets? The tape was to hold the gasket on temporarily, I guess, to get plate installed. Four very tiny dabs of RTV will hold it.
The vent is held with sheet metal screws into a hole. As sclor said. Is that your question? Last edited by AZKen; December 24th, 2019 at 09:14 PM.
|
|
#5
December 25th, 2019, 04:39 PM
|
|||
|
|||
|
Re: Cab questions
Yes, that was my question. Appreciate your help, I think I will be able reinstall the vents with confidence.
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cab support and dimmer switch replacement questions. | Archiver | Previous Forum Posts | 3 | November 30th, 2012 01:46 AM |
| Re: [6066 GMC Truck] Re: Hey Guys and Gals? Questions, Questions, Questions :D | Archiver | Previous Forum Posts | 0 | March 28th, 2003 05:21 AM |
| Hey Guys and Gals? Questions, Questions, Questions :D | Archiver | Previous Forum Posts | 0 | March 27th, 2003 09:14 AM |
| Re: [6066 GMC Truck] Re: Hey Guys and Gals? Questions, Questions, Questions :D | Archiver | Previous Forum Posts | 0 | March 27th, 2003 01:44 AM |
| Re: Hey Guys and Gals? Questions, Questions, Questions :D | Archiver | Previous Forum Posts | 0 | March 27th, 2003 01:23 AM |
