1967 305e V6 Fuel Pump

[James]

Originally Posted by jgpnashville

A question on the water manifold - if I remove it to replace the short hose between the water pump and the manifold, where can I find the gaskets to seal the water manifold against the head? Anyone know a part # for those gaskets?

The gasket for the water manifold is part of the intake manifold gasket. However I might have some that I had cut off. I will check later and will PM you if I have them.

[James]

Originally Posted by jgpnashville

A question on the water manifold - if I remove it to replace the short hose between the water pump and the manifold, where can I find the gaskets to seal the water manifold against the head? Anyone know a part # for those gaskets?

PM sent.

[BobBray]

The intake manifold gaskets actually extend to the end of the heads, sealing the water block-off plates at the rear and the water crossover at the front. You can cut the ends off of new gaskets and just use the part that goes under the crossover or use silicone sealant. The part number for the 305E intake manifold is Victor-Reinz 111048201