Pay Dues or become a Site Supporter |
#1
|
|||
|
|||
V-12 with allison trans
Since this is going into a large vehicle, I used a trans that will haul it. This is a 1942 Ford Siebert Ambulance. It will become a wooden hearse, chauffeur driven, passenger section with bar, and dividing window. Why not, ever seen one before?
Atomman. |
#2
|
||||
|
||||
Re: V-12 with allison trans
Crazy, Insane, Sacrilege!!! But I Love it.
__________________
1961 GMC Suburban 305A Overdrive 1962 GMC Utility 305D |
#3
|
|||
|
|||
Re: V-12 with allison trans
Dual Quad carbs What did you do to the intake manifolds to adapt the carbs?
|
#4
|
|||
|
|||
Re: V-12 with allison trans
Here are my thought on the dual fours. I used a 2 to 4 NHL conversion plate. While they are 2 Holley 600's, I am not convinced it was necessary to machine the intakes. With limited intake restriction, you are going to be limited to a certain air intake volume. The max fuel mix would not be significantly different. What are your thoughts. My two cents
Atomman |
#5
|
|||
|
|||
Re: V-12 with allison trans
In my high school days I tried the 2bbl to 4bbl adapter on my 68 305E. I installed a Holley 780 dual feed square carb bore. The idle was fluctuating up and down, seemed like the adapter wasn't sealing well, don't think the vacuum secondary's ever kicked in. A couple years later I decided to try the Economaster Holley 450cfm mini spreadbore carb with the same adapter, when the secondary's kicked in there was a stumble because there's only so much fuel you can squeeze through a small passage, both episodes only proved the Holley 500 2bbl prevailed with the stock manifold. If you're going to run the stock manifolds specially on the 702 and run 4bbl carbs then the best bet is to modify the stock manifolds to accept a 4bbl base like David Chadwell did several years back. You can't use the Magnum V6 intake manifolds on the 702 due to the spacing these engines have their own specific intake manifolds
|
#6
|
||||
|
||||
Re: V-12 with allison trans
Open the plenum. Good results. Been there an done it. Dual 4's look sick on that 702 though. Super jealous right now.
__________________
"Excuse the rust I use my truck" 1964 GMC 1500 305E/sm420 4 barrel intake mod and dual exhaust. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. 1964 Chevy C20 292/SM420 1966 Chevy C10 292 hotrod 6/TKO600 My youtube channel aka Military Chevy: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. |
#7
|
|||
|
|||
Re: V-12 with allison trans
The v12 will look awesome in the ambulance body, are you using the ford chassis ?
|
#8
|
|||
|
|||
Re: V-12 with allison trans
Using the Ford frame, extended 30 inchs, make a two piece hood
'65 C-10 front cross member w/ disc brakes, if I can get it to fit. Atomman |
#9
|
|||
|
|||
Re: V-12 with allison trans
UPDATE ON THE v-12 IN THE FUTURE HEARSE. HEART TRANSPLANT COMPLETED. Will be at the Turkey Run with it
|
#10
|
|||
|
|||
Re: V-12 with allison trans
That is awesome,keep the pictures coming.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
V-12 with Allison Trans | atomman | Transmissions and Rear Ends | 1 | August 23rd, 2017 08:36 PM |
67 4x4 with allison | Archiver | Previous Forum Posts | 0 | November 28th, 2010 12:34 AM |
Re: Allison Transmission Fluid | Archiver | Previous Forum Posts | 0 | February 7th, 2007 06:30 AM |
Re: Allison Transmission Fluid | Archiver | Previous Forum Posts | 0 | February 7th, 2007 04:30 AM |
Allison Transmission Fluid | Archiver | Previous Forum Posts | 0 | February 6th, 2007 12:36 AM |