Pay Dues or become a Site Supporter |
|
Wheels, Tires, Suspension and Brakes Keep them doggies rollin', rawhide |
|
Thread Tools |
#1
|
|||
|
|||
Tall 15" tires?
I am looking for some tall 15" tires to fit my 62 GMC, most I have found are in the 29-30" range. Does anyone know of a manufacturer that has something a bit bigger in diameter? I have a 3;54 rear end ratio, SM420 tranny.
thanks |
#2
|
|||
|
|||
Re: Tall 15" tires?
You might have to go with a larger rim. I went with 16" rims and my tire diameter is 31.7". I too have a 3.54:1 rear axle and a SM420 transmission.
|
#3
|
|||
|
|||
Re: Tall 15" tires?
James,
You may be right, from all the looking I have done the best is 30.5" diameter and that was in a snow tire. Problem is that I have original 3 piece rims with hub caps that I don't want to give up. Probability is that I won't take it much on highway anyway so it would be hard to justify buying all new rims and tires for an extra 5-7mph on the road. thanks, gg |
#4
|
|||
|
|||
Re: Tall 15" tires?
According to my numbers with a 30.5" tire you will have:
2150 rpm = 55 mph 2350 rpm = 60 mph 2550 rpm = 65 mph 2750 rpm = 70 mph With a 29" tire: 2250 rpm = 55 mph 2450 rpm = 60 mph 2650 rpm = 65 mph 2850 rpm = 70 mph On my truck with 16" rims and a 31.7" tire: 2050 rpm = 55 mph 2250 rpm = 60 mph 2450 rpm = 65 mph 2650 rpm = 70 mph All of these numbers should be within ±2 mph. There is not a lot of different between the tire sizes. So whatever you decide to use, it is not going to make a big difference. |
#5
|
||||
|
||||
Re: Tall 15" tires?
Im running 31x10.5 on min 8 wide wheel lowered 4 inches no rubbing
|
#6
|
|||
|
|||
Re: Tall 15" tires?
Not sure of the height, but I needed a taller tire for the Rears on my '72 C-10. I am using 265/75/15's. Not a whole lot, but it did make a difference.
__________________
Drove and owned many, but some of the more interesting ones were: -'60 GMC 2500 Dump, 305 V-6 -'62 GMC 4000 Flatbed, 305 V-6 -'62 GMC 6500 Flatbed Dump, 478 V-6 -'67 GMC 7500 Box, 6V-53 Detroit -'71 GMC 9500 Flatbed Dump, 637 V-8 |
#7
|
|||
|
|||
Re: Tall 15" tires?
Quote:
Hope this is helpful. |
#8
|
|||
|
|||
Re: Tall 15" tires?
I decided to go with an option that let me keep the 3 piece rims. When I purchased the truck two tires were shot so I replaced them with new keeping the best of the ones left on there, I matched a set of Lee tires for the front. I believe these tires are pretty old and I have been getting the square tire ride for the first hour or so of operation. So I ordered some mud/snow tires from STA (30") that will go on the rear and the ones purchased a couple years ago will go on the front. This should give me some rubber that should last for awhile. I do have a set of chrome spoked wheels that are 15x8" diameter that came with truck if I decide to go to tubeless radials.
|
#9
|
|||
|
|||
Re: Tall 15" tires?
Finally received my snows for the back of my truck after waiting for a few months for delivery. As I mentioned previously, I have the original 3 piece rims on my truck, now the joy of changing the tires on them began. First of all they had a 3 digit date code with the last digit being a 5. Googling the Lee brand showed they were discontinued by Good Year in around 1980. So they may be from 1975 date and been on there for 47 years. No wonder they felt square.
The tires were basically rusted to the rims, after the retaining ring was removed nothing moved. I inflated the tire a bit with the retainer removed so the outside rim portion raised a bit above the edge and smacked it a number of times with a dead blow hammer to break it from the tire. that was easy compared to the reverse side. The tire was mounted on my 60s era manual Coates tire changer, A unit I used when I worked in service stations when in high school, a lot of effort and many rotations lifting from the underside finally broke the bottom free and the tire/tube assembly was removed. Much time was spent removing rust the the outside rim and rim of the wheel, they may have spent time laying on the ground flat so the water seeped into the interior of the wheel and rusted everything, after some time wire brushing every surface and using a grinder with a scotch brite pad attachment the rim was clean on the inside. We are now ready for the tire installation. looks like i am out of room, cont........ |
#10
|
|||
|
|||
Re: Tall 15" tires?
Now on to the the preparing the tire installation. The tires have a tube, and another item called a liner that protects the tube from touching the inside surface of the rim. One has to first install the tube, inflate it to straighten out the creases and let the air out, then the liner is installed, it is pretty wide and goes down each side of the tube about 4", repeat the inflation deflation routine again to get everything to seat. Now position the tire on the rim and slide the valve nozzle into the hole on the rim and the tire assembly will slide onto the rim with no efforts. Nice not having to pry over the outside rim. the outside rim is positioned over the hub, the lock ring goes on top and then the outside of the rim is pushed down the hub for abut 2-3 inches exposing the groove in the rim for the retaining ring. the ring is positioned by prying over the edge onto the groove all the way around. After it snaps into place it is OK to inflate your tire.
I ended up using tires from Specialty Tire of America, I was so happy with the installation I ordered 2 new highway ones for the front too. Interesting note, I priced the tires from Coker and they quoted shipping of $150, but when I ordered them from Jegs, shipping was free, same price per unit. |
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
33" tires on a 1965 k1000 | arepoff | Wheels, Tires, Suspension and Brakes | 5 | June 7th, 2019 08:44 PM |
Looking for 15" 1/2 ton 3 piece rims | jagarra | 1960-1966 GMC Marketplace | 0 | January 3rd, 2019 04:39 PM |
Split Ring 15" Vintage Rims 6 lug w/clips | AZKen | 1960-1966 GMC Marketplace | 2 | December 28th, 2014 07:31 PM |
15", 6 lug Wheels | aphaynes | 1960-1966 GMC Marketplace | 9 | December 20th, 2014 12:05 AM |
Tall Tires | Archiver | Previous Forum Posts | 0 | November 27th, 2002 12:27 AM |