Pay Dues or become a Site Supporter |
|
Transmissions and Rear Ends Three on the tree or four in the floor? Shift it all here. |
|
Thread Tools |
#1
|
|||
|
|||
'62 Rear Bearings & Seals
I have a 1962 K1001 Panel Truck. I lost a rear bearing last week. I'm searching for replacements parts. I believe I have found the correct inner seal and bearing but I'm coming up empty trying to locate that outer seal. Anybody have any luck locating it. I am able to get this info off it "New Departure ?8128". The first digit in not readable.
|
#2
|
||||
|
||||
Re: '62 Rear Bearings & Seals
I googled and started with 18128....when I got to 38128...... Spicer seal for Dana 44. Took me 30 seconds.
Last edited by AZKen; July 28th, 2023 at 03:19 AM. |
#3
|
|||
|
|||
Re: '62 Rear Bearings & Seals
I had investigated that seal before. I don't think it is the correct one. It is designed for a 2.5" shaft diameter. My rear axle location has the seal riding on a 1.5" shaft. Thanks for looking into this.
|
#4
|
|||
|
|||
Re: '62 Rear Bearings & Seals
Quote:
|
#5
|
||||
|
||||
Re: '62 Rear Bearings & Seals
Trailer axles are often 1.5". Could a trailer axle seal work?
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy. |
#6
|
||||
|
||||
Re: '62 Rear Bearings & Seals
The splined axle shaft is 1.5 OD. The outer seal diameter and the bearing diameter are larger out at the hub end.
Sure seems like if the number you gave comes back as 38128 seal, that would be it. The outer is bigger. Measure the seal you need for ID and OD and width and let us know. I hope you are measuring the seal and not the shaft at the wrong place Anyway here is a possibility. SKF 13165 My 1960 K1001 had an original dana 44. I guess you could have a Eaton HO. Doubt it unless someone swapped. Last edited by AZKen; July 30th, 2023 at 01:22 AM. |
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
66 4000 rear axle bearings & seal #'s | animalsservicar | Transmissions and Rear Ends | 0 | August 24th, 2022 03:16 AM |
305e Rod & Main Bearings | kchampagne | GMC V6 and V12 Engines | 3 | January 11th, 2020 04:02 AM |
Rear end seals and bearings | Archiver | Previous Forum Posts | 0 | August 11th, 2009 02:10 AM |
Re: general comments on buying bearings and seals | Archiver | Previous Forum Posts | 0 | July 8th, 2007 02:46 AM |
general comments on buying bearings and seals | Archiver | Previous Forum Posts | 0 | July 3rd, 2007 02:38 AM |