Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
#1
September 22nd, 2022, 03:04 PM
|
|||
|
|||
Heater controller
I have 1966 GMC 1000 that I'm replacing the heat control levers. My question is there is a bracket that holds the bottom half of the control tight to the dash and I cannot figure out how it attaches to the dash.It's kindof a Z shaped bracket.
|
|
#2
September 23rd, 2022, 11:36 AM
|
||||
|
||||
|
Re: Heater controller
It rests/sits on the lower flange edge and 2 screws are use to pin the top in, it can't come out.
|
|
#3
October 2nd, 2022, 10:27 PM
|
||||
|
||||
|
Re: Heater controller
JeffO:
Is this the bracket you are looking for? It bolts to the bottom of the heater control and to the bottom of the dash using one of the bolts in the glove box hinge. Hope this helps. Regards Steve New Orleans
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: Heater upgrades from std. heater for 'burbs and panels in cold climates??? | Archiver | Previous Forum Posts | 0 | December 27th, 2008 12:06 AM |
| Re: [6066 GMC] Re: heater controller | Archiver | Previous Forum Posts | 0 | May 18th, 2007 01:40 AM |
| Re: [6066 GMC] heter controller | Archiver | Previous Forum Posts | 0 | May 17th, 2007 02:47 PM |
| Re: heater controller | Archiver | Previous Forum Posts | 0 | May 17th, 2007 01:04 AM |
| heter controller | Archiver | Previous Forum Posts | 0 | May 15th, 2007 01:17 AM |
