Pay Dues or become a Site Supporter |
|
General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
|
Thread Tools |
#11
|
|||
|
|||
Re: clutch problem
Feel free to crawl under my truck and bench press that SM420 a few times!
|
#12
|
|||
|
|||
Re: clutch problem
thanks Jim a, I'll try that
|
#13
|
|||
|
|||
Re: clutch problem
It is important to make sure you have the full stroke range at both the master and slave cylinders.
There needs to be a little slack at the throwout bearing to protect it, but also enough travel of the slave rod to fully release the clutch disc. I fought this situation for years and the fix. after waiting too long, was very difficult. |
#14
|
|||
|
|||
Re: clutch problem
When you say you can’t get it into gear with the engine running I assume you mean the gears grind when you try to engage? I believe ‘63 was the same as my ‘60. Is it a sm420 with a hydraulic clutch?
Sounds to me like the flywheel is not disengaging which is throwing the synchro off. Try cycling through all the gears with the engine off. Ending in 4th. Than start it up and see if you can put it back into 4th. Also try pumping up the clutch a few times before shifting. May or may not work but could give you a better idea of what is going on. There is an adjustment nut where the slave cylinder meets the fork. Try setting it out further. Or master/slave cylinders could be on there last leg. Get eyes on the slave cylinder when someone pumps the clutch and see how much travel you get. |
#15
|
|||
|
|||
Re: clutch problem
thanks for the info
|
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with clutch disengaging | Clarke | Transmissions and Rear Ends | 36 | August 12th, 2022 03:15 AM |
FS- Late Mechanical clutch bell housing, flywheel and clutch | zigafomana | 1960-1966 GMC Marketplace | 11 | April 1st, 2014 02:26 AM |
6066gmc 60 model clutch problem | Archiver | Previous Forum Posts | 0 | July 4th, 2006 02:25 AM |
Re: have a problem | Archiver | Previous Forum Posts | 0 | December 3rd, 2003 01:24 AM |