6066 (1960-1966) GMC Truck Club Bitcoin now accepted here! 
Pay Dues
Pay Dues or become a Site Supporter
 



Go Back   6066 (1960-1966) GMC Truck Club > 6066 GMC Truck Club Forum > GMC V6 and V12 Engines
#Sponsored

GMC V6 and V12 Engines Engine repair and rebuilding

Reply
 
Thread Tools
  #1  
Old November 9th, 2024, 07:45 AM
BobBray BobBray is offline
-= Dues Paid =-
 
Join Date: Feb 2013
Location: Los Angeles, CA.
Truck: 1967 CM 2500
Posts: 264
Thanks: 4
Thanked 4 Times in 3 Posts
Rep Power: 157
BobBray will become famous soon enoughBobBray will become famous soon enough
Default Spark Plugs

What is the general consensus on spark plugs these days? For a long time I was running the specified AC C44NS commercial plugs in my 351E. Even though obsolete, they were readily available on Ebay fairly cheap. Truck ran O.K., but it did tend to run on a bit shutting off when good and hot like after a long drive in traffic. I was thinking the plugs might be a little too 'hot' for non-commercial driving. I changed the plugs to the currently recommended platinum AC 41-828, gapped at .040. Runs better! Quiker starts, smoother hot idle and no run-on. I do have a Pertronix ignition with their 3.0 ohm 'Flamethrower' coil, so I am sure the increased gap is not an issue. The old C44NS showed no fouling, oil or excess carbon deposits, insulator tan, end of electrode gray, moderate gap increase.
Reply With Quote
  #2  
Old November 10th, 2024, 06:30 PM
Prowbar Prowbar is offline
-= Dues Paid =-
 
Join Date: Dec 2020
Location: Friesland, the Netherlands
Truck: 1965 GMC 1500, 478 V6, SM420
Posts: 451
Thanks: 11
Thanked 13 Times in 12 Posts
Rep Power: 203
Prowbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the rough
Default Re: Spark Plugs

I am running the 478 on propane mostly. Propane burns hotter meaning you need colder plugs. The porcelain on the AC R44XLS plugs in the 305 and 478 was very white. I switched to R43XLS plugs and they are still on the hot side, but a little better.

I am now running NGK BRP6ES plugs (same heat grade as the 43) and I like the NGK plugs better. Can't say I noticed a smoother idle or anything.

I was running the HEI ignition but switched back to points. I find more joy in keeping things original/OEM than aftermarket stuff. No difference in idle or cold starting for me. Still using the stock coil with the resistor wire.

Last edited by Prowbar; November 10th, 2024 at 08:24 PM. Reason: typo
Reply With Quote
  #3  
Old November 10th, 2024, 08:20 PM
AZKen's Avatar
AZKen AZKen is offline
-= Dues Paid =-
 
Join Date: Jul 2014
Location: AZ
Truck: 6066GMC
Posts: 1,651
Thanks: 0
Thanked 4 Times in 4 Posts
Rep Power: 529
AZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really niceAZKen is just really nice
Default Re: Spark Plugs

Commentary, not aimed at anyone:

It really does not matter brand wise. The right threads, the right protrusion into the combustion chamber and gap is all that matters. Plugs are not high tech. They just make a spark. The only moving part is the hype. Condition of motor, rings, timing, rich, lean, manifold heat leaks are what fouls a plug. As some folks have found, going "Hot" is not advantagous and can cause trouble.

Don't fall for sales words like "Hot Spark", "Flamethrower" "performance plugs" "Split Fire"..................We have VERY LOW RPM "Non performance", reliable, high torque, super engineered motors that run on any properly gapped spark. Just make sure you have good plug wires.

Last edited by AZKen; November 10th, 2024 at 08:45 PM.
Reply With Quote
The Following User Says Thank You to AZKen For This Useful Post:
jerrspud (November 21st, 2024)
  #4  
Old November 10th, 2024, 08:27 PM
Prowbar Prowbar is offline
-= Dues Paid =-
 
Join Date: Dec 2020
Location: Friesland, the Netherlands
Truck: 1965 GMC 1500, 478 V6, SM420
Posts: 451
Thanks: 11
Thanked 13 Times in 12 Posts
Rep Power: 203
Prowbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the roughProwbar is a jewel in the rough
Default Re: Spark Plugs

I agree on that, Ken. A good spark plug won't fix an engine that had bad rings, leaking valves, poor A/F ratio or the like.
Reply With Quote
  #5  
Old November 11th, 2024, 06:13 PM
BobBray BobBray is offline
-= Dues Paid =-
 
Join Date: Feb 2013
Location: Los Angeles, CA.
Truck: 1967 CM 2500
Posts: 264
Thanks: 4
Thanked 4 Times in 3 Posts
Rep Power: 157
BobBray will become famous soon enoughBobBray will become famous soon enough
Default Re: Spark Plugs

There's a lot of 'gimmicky' spark plugs out there, I agree they don't really work any better than standard plugs. One thing I noticed about the original C44NS plugs is that the center electrode is quite recessed, which usually means hotter plug. The 41-828 electrode protrudes further out. Not sure what the number mean on newer AC plugs, other than '41' means spark plug and the '800' series means 'platinum'.
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Re: Spark Plugs Archiver Previous Forum Posts 0 May 23rd, 2009 04:05 AM
Re: Spark Plugs Archiver Previous Forum Posts 0 May 23rd, 2009 02:00 AM
Re: Spark Plugs Archiver Previous Forum Posts 0 May 21st, 2009 06:43 AM
Spark Plugs. Archiver Previous Forum Posts 0 October 6th, 2005 02:23 AM
What spark plugs? Archiver Previous Forum Posts 0 July 7th, 2003 02:28 AM


All times are GMT +1. The time now is 10:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd 871733152557|1732052750|0