![]() |
![]() |
|
Interiors, Dash, Lights and Electrical Everything Inside |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
A new day a new issue lol, this time it's the RF turn signal. It was working fine yesterday, but today it's not, the rest are working, also hit the warning flasher and works perfectly, just the RF signal not working. Not my strong area, but guessing guessing a relay, maybe...thoughts? On a 66 gmc 1500..
|
#2
|
|||
|
|||
![]()
Have you tried changing the bulb? Another possible cause is the turn signal switch.
|
#3
|
||||
|
||||
![]()
May be the tangs on bulb socket are not grounding in the hole, but odd that same bulb works when on warning mode?
What relay are you talking about? After you fiddle with the socket and verify good ground, swap L and R bulbs to see if issue follows bulb or stays with socket, then I have some tests for you. Get an ice pick voltage tester. $7 Last edited by AZKen; March 10th, 2023 at 09:36 PM. |
#4
|
|||
|
|||
![]()
Will try switching bulbs, but as you said odd that it works when E flasher is on. Will get back to ya in a bit. And thanks Azken, you are the master indeed.
|
#5
|
|||
|
|||
![]()
And I was referring to flasher relay if there is such a critter...
|
#6
|
|||
|
|||
![]()
Azken, it must've been a bad ground or bulb, I changed the bulb and sanded the little ground clips and its back to working again....at least until the gremlins get bored again...
|
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turn signal dilemma | Forgue | Interiors, Dash, Lights and Electrical | 3 | October 25th, 2021 06:01 PM |
Re: turn signal switch | Archiver | Previous Forum Posts | 0 | December 11th, 2006 12:00 AM |
turn signal wiring | Archiver | Previous Forum Posts | 0 | January 9th, 2005 05:26 AM |
turn signal Troubles | Archiver | Previous Forum Posts | 0 | December 12th, 2004 12:27 AM |
1965 TURN SIGNAL | Archiver | Previous Forum Posts | 0 | July 10th, 2003 01:04 AM |