Pay Dues or become a Site Supporter |
|
GMC V6 and V12 Engines Engine repair and rebuilding |
|
Thread Tools |
#11
|
||||
|
||||
Re: Getcha Motor Runnin - Engine Tuning Specs for 305 V6
__________________
1961 GMC Suburban 305A Overdrive 1962 GMC Utility 305D |
#12
|
||||
|
||||
Re: Getcha Motor Runnin - Engine Tuning Specs for 305 V6
Quote:
|
#13
|
||||
|
||||
Re: Getcha Motor Runnin - Engine Tuning Specs for 305 V6
you can set the valves either way hot. i have done it both ways. also if you had rather run the valves cold, i add .002" to the hot settings.
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. |
#14
|
|||
|
|||
Re: Getcha Motor Runnin - Engine Tuning Specs for 305 V6
I find that guy a little hard to listen to.
Mainly, I wonder why there is no oil flowing when he runs the engine for extended periods with the valve covers off. Does he say to adjust a valve when there is no tension on the spring? I like to be sure the I am on the absolute flat of the cam. |
#15
|
|||
|
|||
Re: Getcha Motor Runnin - Engine Tuning Specs for 305 V6
My engine oiled very little to the heads before I milled out the slots in the camshaft to increase the oiling. Now I get a lot more oil to the top end - can't hurt in my opinion.
I set the valves with the engine off. I remove the valve covers and put a wrench on the front crankshaft bolt and start on cylinder 1 at TDC at the compression stroke. I set the valves following the firing order, making sure I am on the base circle of the cam. Ignition timing is usually set between 8-10 degrees initial. I check dwell with the dwell meter (I have a distributor without a window) I take off the cap and remove the rotor. Then slightly loosen to the hold down screw of the points and use the screw driver slot to adjust. Takes a couple of times to go back and forth since you need to put the rotor and cap back on and run the engine to check the dwell. The nice thing about the GMC V6 is that you can set the lash with one wrench (no hold down nut to mess with) and that the rocker pedestals are made of aluminum, thereby keeping the lash the same between hot and cold due to the larger expansion/contraction rate of the material. I have read in the advertisements that you can set the lash either hot or cold and that the lash is always the same - and they are correct! No need to add any lash when cold. |
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Re: 305 V6 Motor Mounts | Archiver | Previous Forum Posts | 0 | November 27th, 2007 01:27 AM |
Re: [6066 GMC] 305 V6 Motor Mounts | Archiver | Previous Forum Posts | 0 | November 26th, 2007 04:45 AM |
Re: [6066 GMC] 305 V6 Motor Mounts | Archiver | Previous Forum Posts | 0 | November 26th, 2007 01:14 AM |
Re: [6066 GMC] 305 V6 Motor Mounts | Archiver | Previous Forum Posts | 0 | November 20th, 2007 12:42 AM |
305 V6 Motor Mounts | Archiver | Previous Forum Posts | 0 | November 20th, 2007 12:00 AM |